Company news

1. Lightweight: The structure is airtight and features a unique groove design, making connection convenient and simplifying installation and maintenance. 2. The optical cable is specially designed with an elastic side, which is suitable...

1. Category 5 Network Cable: Category 5 cable supports a transmission speed of 100 Mbps and has been replaced by Category 5 cable; the frequency of the signal transmitted by Category 5 cable is 100 MHz and the speed...

(1) Integration: Office cabling must meet the transmission requirements of various analog or digital signals, and combine all language, data, image, and monitoring equipment cabling into a standard E cabling system...

(1) Pure copper. Pure copper is the best and highest quality network cable. It is suitable for PoE power supplies and has low resistance to prevent power loss during transmission. This type of network cable is the best cable...

1. Check the Color: First, open the outer jacket of the network cable and test it. You can now see the network wires intertwined and compare them carefully. If the green and white wires and the blue and white wires are...

GY--Outdoor fiber optic cable GJ--Indoor optical cable MG--Coal mine optical cable II. Reinforcing element types (no model)--Metallic reinforcing member F--Non-metallic reinforcing member III. Structural characteristics...

The main factors that cause fiber attenuation are: intrinsic factors, bending, extrusion, impurities, lack of uniformity, and coupling. 1. Intrinsic: This is the inherent loss of the fiber, including: Rayleigh scattering, absorption...

Advantage 1. High capacity to withstand extreme weather conditions (strong winds, hail, etc.). 2. Strong temperature adaptability and small coefficient of linear expansion to meet the needs of harsh conditions...

Based on the different components and structures of OPGW, OPGW is classified as follows. 2.1 According to the material of the light unit's protective tube, the OPGW structure type is divided into stainless steel OPGW tube and...

1. Aerial fiber optic cables are primarily used for secondary trunk lines and underground fiber optic cable lines, and are suitable for areas with flat terrain and minimal voltage fluctuations. 2. There are mainly two suspension methods...

Single-mode fiber (single-mode fiber): light enters the fiber at a specific angle of incidence, and complete emission occurs between the fiber and the cladding. When the diameter is small, light is only allowed to pass in one direction...

Different materials: Most fiber optic cables are made of glass fiber, while network cables are made of copper wires. Different transmission speeds: The best Category 7 cables in network cabling...